|
Needle burner |
inner hole diameter Φ 0.5mm ± 0.1mm, Diameter,≤Φ 0.9mm, |
|
|
length ≥ 35mm, stainless steel |
|
Burner angle |
0~45° (adjust flame height) |
|
Thermocouple |
Ø0.5mm Type K (Ni/Cr - Ni/Al), armored sheath can withstand |
|
|
temperature-40°C~ 1100°C |
|
Burning time |
0-999.9 s ± 0.1 s adjustable (usually selected for 30s) |
|
Hold Burning time |
0-999.9 s ± 0.1 s, automatic recording, manual time-out |
|
Flame Height |
12mm ± 1mm (with height measurement instruments) |
|
Flame Gas |
butane gas/Butane gas, min. 95% purity (can use bottled lighter gases) |
|
Temperature Test Range |
0~1000°C |
|
Flame Temperature Requirements |
from 100 °C ± 2 °C liters to 700 °C ± 3 °C time in 23.5 seconds ± 1 seconds |
|
Standard Copper Block |
4mm±0.01mm, weight.0.58g±0.01g before drilling. Cu-ETP |
|
Test process |
automatic control, independent convulsions |
|
Chamber |
≥0.5m3 |
|
Control |
Using single chip microcomputer + touch screen control |
|
Consult standard |
GB/T5169.10-2006 , IEC60695-11-5:2000,UL746A |
|
Power Supply |
800VA ,220V, 48-60Hz |
|
Display panel language |
English(customize available) |
The Single Wires & Cables Vertical Flammability Tester is an essential tool for testing the flammability of wires and cables. The International Electrotechnical Commission (IEC) has set the standard for this test, which is IEC60332. The purpose of this test is to ensure that the wires and cables used in electrical and electronic equipment meet certain fire safety standards.
The horizontal combustion tester is applicable to the measurement of relative combustion rate, flame retardance and horizontal combustion performance of various textile fabrics, clothing, tents, etc., especially automotive interior fabrics.
